Holster screws and threadlocker
Oct 18, 2026
Loose screws are the single most common maintenance issue we see. Kydex flexes every time you move, and that constant working will back retention, clip and mounting screws out over time.
Use a medium strength threadlocker
Apply a medium strength threadlocker such as Loctite 243 when you first fit the holster and again whenever you adjust the tension. Then check the screws periodically as part of your normal gear check.
Do not use a high strength permanent grade. You will not be able to adjust the holster afterwards.
Adjusting retention
A new holster is meant to feel tight and will loosen slightly as it beds in. Adjust the tension screws once it has settled, then threadlock them again.
Lost a screw or a clip?
Contact us and we will send replacements. Broken clips and loose screws are replaced free of charge at any point under our warranty.
Keep it clean
Keep the shell clean and free of grit. Rinse it with clean water and let it dry fully whenever it gets dirty. Do not oil the holster and do not use solvents on it.
More on setup and care: Holster Setup & Instructions and setting up an appendix IWB holster.